DeviceNet 通讯模块安装手册

DeviceNet network 3) Address selector 4) Baud rate selector 5) Three LED status indicators for monitor. (Refer to the figure below) 2. Network Wiring: Picture right hand side below shows rough wire configuration. Refer to DeviceNet

wiring spec for physical wire connection.

3. Mounting Method: Picture right hand side below shows how to mount this communication module onto DIN Rail 42.0 [1.65]100.0 [3.94]34.0 [1.34] 4. Power Supply: No external power needed. Power is supplied via RS-485 that is connected to VFD series. Six pins RJ-11, which is packed together with this communication module, is used to connect the RS-485 between VFD series and this communication module for power. This communication module will perform the function once is connected. Refer to following paragraph for LED indications. 5. LEDs Display: SP: Green LED means in normal communication, Red LED means abnormal. Module: Green blink LED means no I/O data transmission, Green steady LED means I/O data transmission OK. Red LED blinking or Red LED mean module communication is abnormal. Network: Green LED means DeviceNet in normal communication, Red LED means abnormal ★ Refer to user manual for detail information-- Chapter 5 Troubleshooting.

92.0 [3.62]DeviceNet通讯模块安装手册 1. 面板外观：里头包含一个与VFD系列连接的RS-485通讯接口、连接DeviceNet通讯网路接口，

以及地址和鲍率的选择开关，还有三个状态显示灯以显示目前此通讯模块运行状态。请见下图。

2. 网络示意：下图为简易接线示意图，实际现场配线请依循DeviceNet标准规范实施。

3. 固定方式 (Mounting Method)：按照底下图标说明，将装置正确配置在DIN Rail上面。 42.0 [1.65] 100.0 [3.94]34.0 [1.34] 4. 电源需求：由VFD系列的RS-485通讯口供电，不需要外接电源。电源接线方式请使用包装盒内所附RJ-11(6 PINS) 接头的传输线，一端接在VFD系列的RS-485通讯口，另一端则接在此通讯模块的RS-485通讯口。完成此接线，则此通讯模块即可开始运行。灯号指示的部分请参照第5点说明。 5. 灯号显示： SP：绿灯表VFD系列通讯正常，红灯表异常。 Module：绿灯闪烁表无I/O data传输；绿灯则表有 I/O data传输。 红灯闪烁及亮红灯则表此通讯模块模块异常。 Network：绿灯表DeviceNet通讯正常，红灯表异常。 ★详细资料请参考使用手册—Chapter 5 Troubleshooting。 50116201200407-20

HTTP://www.delta.com.tw

DNS1

92.0 [3.62]